Skip to main content

U-Bracket with 2 Pin and Hexagon Bolt on the Side

Product information "U-Bracket with 2 Pin and Hexagon Bolt on the Side"

Specifications:

U-bracket / carrier clamp for railings: 45 mm with 4 holes M5 thread 
Cover width: to 100 mm
pin length: 100 mm
Material: 1.4301 stainless steel

Assembly:

Mounting the wires (one spring and 2 sleeves are mounted per section) Cut the stainless steel cable to the appropriate length with a reserve of approx. 20-25 cm.

1. On the pin without spring: The stainless steel cable is passed through the sleeve and then through the hole on the pin. The rope is then pulled through the sleeve again and the resulting loop is tightened to the pin. Crush the sleeve with the clamping pliers – to be on the safe side, squeeze in two places.

2. On the spring: Hook the spring to the pin of the next holder, pull the other side of the rope through the sleeve, then pass it through the other eye of the feather and through the sleeve again. Tighten the end of the rope to tension the spring, push the sleeve forward to the pin, hold on and squeeze the sleeve twice. Pinch off the rest of the rope immediately behind the sleeve.

 Application:

Railings, beams, gutters
 

Please enter a valid email address.
Please enter a valid question.
Fields marked with * are mandatory.

There aren't any asked questions yet.
Stainless Steel Rope 0.54 mm thick 1x7 on Plastic Spool made of Stainless Steel
Choose You die Size: 100 m / Spool
€15.00* previously €15.00*
Tension Springs made of 1.4310 Stainless Steel
€0.20* previously €0.20*
Clamping Sleeves 2 mm x 20 mm
Material: Stainless steel Rust-free
Variants from €0.16*
€0.20* previously €0.20*