1 row adjustable solar pigeon repellent spikes BLACK 50 cm long made of stainless steel
Product number:
215V110SCH
Product information "1 row adjustable solar pigeon repellent spikes BLACK 50 cm long made of stainless steel"
Specifications:
Bar thickness of the tips: 2.0 mm
Bar length of the tips: adjustable up to 110 mm (128 mm with strip)
Center spacing: 25 mm
Technology: Pinned (movable) - New! A protected product of the company ZIWI
Strap length: 500 mm (with 10 oval holes 4.2 x 10 mm)
Band width: 18mm+50mm
Band thickness: 0.8 mm
Material: 1.4301 stainless steel
Bar thickness of the tips: 2.0 mm
Bar length of the tips: adjustable up to 110 mm (128 mm with strip)
Center spacing: 25 mm
Technology: Pinned (movable) - New! A protected product of the company ZIWI
Strap length: 500 mm (with 10 oval holes 4.2 x 10 mm)
Band width: 18mm+50mm
Band thickness: 0.8 mm
Material: 1.4301 stainless steel
Colour: black matt powder-coated RAL 9005
Important:
The spikes must rest on the roof tiles so that pigeons cannot push them up.
Important:
The spikes must rest on the roof tiles so that pigeons cannot push them up.
Installation instructions/tips:
Tip 1 – Clips:
1. Check in advance whether the clips are suitable for your solar frames and whether your spike strips are compatible with this type of installation.
2. Place the spike strip flush against the module frame (the strip must not protrude beyond the module frame).
3. First attach the clip to the top of the edge module and then press the clip firmly against the module frame at the bottom.
4. We recommend using 3 clips for a 50 cm strip.
5. The solar clip will be deformed during disassembly and can therefore no longer be used for a new installation.
Compatible with: 2830F(SCH), 2832F(SCH), 2835F(SCH), 2838F(SCH), 2840F(SCH)
Tip 2 – Adhesive:
Important:
Pay attention to the temperatures! Do not apply adhesive to modules that are too warm, so start as early in the morning as possible (especially in summer, before the panels heat up).
1. Before gluing, all surfaces should be cleaned. Only use alcohol-based cleaners or primers for this (the surface should be free of dust and grease).
2. To ensure good adhesion, glue should be applied to the entire surface (do not use the adhesive sparingly). In addition, the profiles can be roughened with a metal brush or sandpaper. One cartridge should be sufficient to cover the entire surface (no more!). The adhesive should also come out at the sides and through the holes. After application, there should still be a 2 mm thick layer of adhesive between the solar system and the spikes so that the materials can expand. If the spikes are removed, the system will remain undamaged.
For older systems that are no longer under warranty, the PV spikes can also be attached with screws. Please check first that there are no cables running behind the frame.
Area of application:
Solar systems, photovoltaic systems
There aren't any asked questions yet.
Soft Cleaner 500 ml for Metals and Glazed Surfaces (Removes Grease, Oils, Dust, etc.)
€12.00*
previously €12.00*